Final Camera Mount

Here is a picture of the latest and best-so-far camera mounting arrangement for the front of the trike. You can see the camera is mounted in a rubber microphone clip (MY100) which is attached to the support shaft. I also tightened up the accessory bar which is connected to the blue frame (derailer post) and that made a lot of difference. I run the camera's cable down the front of the frame and along the bottom and then connect it to the AV500 in front of the seat. The little length of cable between the camera and the coils seems to be enough to let the camera twist freely without getting tangled.

On this closeup picture you can see the bolt assembly better. The lock nuts work much better than the wingnuts did and the neoprene washers do a good job at keeping the whole assembly tight while still allowing it to twist. The basic mic clip seems to provide just the right amount of dampening without letting the camera bounce around too much.